cecotec CONGA 5290 ULTRA Manuel D'instructions page 39

simulating real scrubbing moves. It will start cleaning in Edge mode, then in swaying
motion and finally return to the charging base directly.
It can be activated from the app.
− Manual mode: to carry out a manual cleaning, use the direction buttons on the app to take
the robot to the specific spots where it must clean.
It can be activated from the app.
− Back home mode: Select this mode at any point of any cleaning cycle and during any of the
modes, the robot will automatically return to the charging base.
It can be activated from the robot and the app.
− Smart Area mode: Once the home's map has been saved, select this mode for the robot
to clean a specific area in zigzag motion. The robot will clean the selected area and then
will return directly to the charging base. You can set more than 1 area at the same time.
The robot will only clean the area selected in the map, therefore it will go to the point and
return to the base without vacuuming.
It can only be activated from the App.
− Spot mode: Select this mode if you want to clean thoroughly a specific point in the map,
making the most of the robot's maximum power. The robot will clean a 2x2 m zone in zigzag
motion and then will return directly to the charging base when cleaning is completed. The
robot will only clean the area selected on the map, therefore it will go to the point and
return to the base without vacuuming.
It can only be activated from the App.
− Restricted Area mode: Select this mode and delimit in the map specific areas where you
do not want the robot to clean. You can set more than 1 restricted area at the same time
on the map.
It can only be activated from the App.
− Complete cleaning: use this mode to carry out a deep, thorough cleaning of your home.
Final cleaning
− Before returning to the charging base, the robot moves forward and backward several
times in order to eliminate any rests of dust from the brush.
ENGLISH
39