HQ Power VDPL300BA Notice D'emploi page 4

• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Description
1. fuse
2. power input
3. DMX output
4. remote control input
5. DMX input
6. sensitivity adjustment
7. display
8. menu control push buttons
5. Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Operation
Switch on your ARAZU II by connecting the power plug to the mains. Disconnect from the mains to switch off. Select
with UP/DOWN, confirm your selection with ENTER.
• Sound/Master-Slave Operation
Interconnect the master ARAZU II and the slave ARAZU IIs
using standard DMX cables through the XLR inputs and
outputs. Attribute the G.1 address for the master unit;
attribute an S.x address for any slave unit. The units will now
react to sound.
VDPL300BA
4 HQPOWER