HTW ADMIRA FST3-140ADM Manuel De L'utilisateur Et D'installation page 52

Avoid button:
2
1. When the unit is on, press this button to initiate avoiding direct airflow blowing on the body
function.
2. Press " Power " , " Swing " or " Avoid " button will stop this function.
3 P ower button: Operation starts when this button is pressed and stops when you press the
button again.
Fan button: This button is used to select the desired fan speed. Each time you push the
4
button, the fan speed is shifted in the following sequence:
LOW MED
Fan speed display:
1 2
Select LOW fan speed and zones 1~2 will illuminate.
Select MED fan speed and zones 1~4 will illuminate.
Select HIGH fan speed and zones 1~6 will illuminate.
Select AUTO fan speed and zones 1~7 and "AU" will illuminate .
Note: Under Turbo mode, zones 1~7 will illuminate with super high fan speed.
Swing button:
5
1. This button is used to set the horizontal and vertical airflow.
2. Each time you press this button, the airflow settings change as follows: Set
vertical airflow→ Cancel vertical airflow→ Set horizontal airflow→ Cancel horizontal airflow
→ Simultaneously set vertical and horizontal airflow→ Cancel vertical and horizontal airflow
→ Set vertical airflow.
WARNING: Manually moving the horizontal and vertical airflow direction louvers could
button
6
Under Test Running mode, press "
1.
T4 and error codes in turns.
2. Press " " button to incerase the set temperature in 1°C incerements. Max. temperature is
30°C or 28°C(model dependent).
Press " " button to decerase the set temperature in 1°C incerements. Min. temperature is
16°C/17°C or 20°C(model dependent).
HIGH AUTO
4 6 7
damage the air conditioner.
" and " " button can display the temperature of T1,T2,T3
11