Publicité
Les langues disponibles
Les langues disponibles
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR TRIMMING PURPOSES ONLY
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
OPERATING INSTRUCTIONS
• The battery is not intended to be replaced by the user.
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the
battery.
• The battery is to be disposed of safely.
CHARGING CLIPPER
The AC adapter is intended for use with Andis Model LCL lithium-ion battery with a
rated capacity of 4.5V
1.2A. Remove the clipper and AC adapter from the carton.
Plug the AC adapter into a 100-120V, 50-60 cycle AC outlet, or as noted on the unit.
Plug the adapter cord directly into the receptacle on the bottom of the clipper
(Figure A). The clipper ON/OFF switch must be in the OFF position for the battery
to charge. The green light on the clipper will turn ON when the clipper is charging.
When clipper is fully charged, the green light will turn OFF.
The clipper has not been charged at the factory. Please charge the clipper for
3-5 hours before FIRST use for maximum performance. When battery is fully
charged, clipper can be used for up to 90 minutes of continuous run time.
After first use, clipper will fully charge in a minimum of 2 hours.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Make sure ON/OFF switch on the clipper is OFF.
3. Check to make sure adapter cord is plugged firmly into clipper.
4. If failure to charge still exists, return clipper to Andis or an Andis Authorized
Service Station for examination and repair or replacement.
CORDED OPERATION
If the clipper powers OFF in the middle of a clipping job, the adapter cord can be
attached to continue use in corded operation. When the clipper is running with the
adapter cord attached, the green light will remain ON even if the battery is not fully
charged. The clipper will not charge while in use with the cord attached. After
using your Andis clipper, rewrap cord and store in a safe place.
4
All manuals and user guides at all-guides.com
B
A
D
E
ADJUSTMENT
LEVER
CLIPPING GUIDE
Description
Clipping Direction
With hair grain
Standard Andis Blade
Against hair grain
With hair grain
1/8" Attachment Comb
Against hair grain
With hair grain
1/4" Attachment Comb
Against hair grain
With hair grain
3/8" Attachment Comb
Against hair grain
With hair grain
1/2" Attachment Comb
Against hair grain
With hair grain
3/4" Attachment Comb
Against hair grain
With hair grain
1" Attachment Comb
Against hair grain
C
SNAP!
F
OIL
Approximate Length of Cut
Fine
Coarse
1/16" (1.6 mm)
3/16" (4.8 mm)
1/32" (0.8 mm)
1/8" (3.2 mm)
1/4" (6.4 mm)
3/8" (9.5 mm)
1/8" (3.2 mm)
1/4" (6.4 mm)
3/8" (9.5 mm)
1/2" (12.7 mm)
1/4" (6.4 mm)
3/8" (9.5 mm)
1/2" (12.7 mm)
5/8" (15.9 mm)
3/8" (9.5 mm)
1/2" (12.7 mm)
5/8" (15.9 mm)
7/8" (22.2 mm)
1/2" (12.7 mm)
5/8" (15.9 mm)
7/8" (22.2 mm)
1-1/8" (28.6 mm)
3/4" (19.0 mm)
1" (25.4 mm)
1-1/8" (28.6 mm)
1-3/8" (34.9 mm)
1" (25.4 mm)
1-1/4" (31.8 mm)
5
Publicité
