Trix Minitrix 110 Serie Mode D'emploi page 7

Safety Notes
• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The wire used for feeder connections to the track may be
a maximum of 2 meters / 39 inches long.
• WARNING! Sharp edges and points required for operation.
General Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
All manuals and user guides at all-guides.com
Functions
• Trix locomotives can be operated on al 2-rail DC systems
• An electronic overload protection is build in to protect the
• Triple headlights that change over with the direction of
• Locomotive comes with NEM 651
• Can be switched to catenary operation
• Analog 14 volts DC, digital 22 volts AC.
• Trix motor vehicles must not be operated on digital
• Based on the NEM 661 standard, the speed of the loco-
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
with conventional DC power packs (12 volt DC).
model.
travel.
digital connector.
systems without an in-built engine decoder (Motor can
be damaged!).
motive at 12 volts is set approximately at the maximum
speed for the prototype.
NEM
7