tomado TVC2501B Mode D'emploi page 16

Check that the voltage stated on the information plate matches the voltage used in your region.
SWITCHING ON THE VACUUM CLEANER
1. Place the vacuum cleaner on a sturdy and flat surface.
2. Carefully pull the cord out of the vacuum cleaner until you reach the required length or up to the yellow mark and insert
the plug in a power socket. Never pull the cord further than the red mark.
3. Switch on the vacuum cleaner by pressing the on/off button
4. Depending on the surface to be cleaned, you can adjust the brushes in the floor nozzle.
When cleaning hard floors, you must make sure the brushes are extended.
When cleaning floor coverings or floor cloths, the brushes must be retracted.
When it is difficult to move the floor nozzle over the floor, you can adjust the suction power with the min - max
suction power controller or with the extra suction power controller on the handle of the hose.
SWITCHING OFF THE VACUUM CLEANER
1. Switch off the vacuum cleaner by pressing the on/off button
2. Remove the plug from the socket, hold the plug and allow the cord to wind automatically by pressing the button
for automatic rewinding
automatically wound up in the vacuum cleaner.
Regularly check the hose, dust reservoir and filter to prevent problems. Empty the hose when it is clogged. Empty the dust
reservoir when it is full and clean or replace the filters when they are dirty.
EMPTYING OF THE DUST RESERVOIR
1. Grasp the dust reservoir handle and press the silver unlocking button on top of the vacuum
cleaner [4] to unlock the dust reservoir.
2. Lift the dust reservoir upwards and pull it towards you.
3. Hold the dust reservoir by the handle while holding it over a waste bin. Remove the dust
reservoir cover by pulling the cover upwards at the back as in figure 2.
4. Gently shake the dust reservoir empty in the waste bin.
5. Put the cover back on the dust reservoir. You hear a click when it is properly closed again.
6. Put the dust reservoir back on the vacuum cleaner. You hear a click when it is properly in place.
with your foot. Guide the cord with your hand to prevent possible damage. The cord is
MAINTENANCE
EN - 16
USE
with your foot.
with your foot.
2
1
fig. 1
2
1
fig. 2