Midea MP08DRWBA1RCM Mode D'emploi page 16

Control Panel Features
NOTE: The following control panels
purchased may be slightly different according to the models. Your machine may not contain some indicators or
buttons. The actual shape shall prevail.
Wireless button(On some models)
Used to initiate the wireless connection mode. For
Wireless
the first time to use wireless function, press the
wireless button for 3 seconds to initiate the wireless
connection mode. The LED DISPLAY shows 'AP' to
indicate you can set wireless connection. If
connection(router) is successful within 8 minutes,
the unit will exit wireless connection mode
automatically and the wireless indicator illuminates.
If connection is failure within 8 minutes, the unit
exits wireless connection mode automatically. After
Wireless connection is successful, for some models
you can press Wireless and DOWN (-) buttons at
the same time for 0.5 seconds to turn off Wireless
function and the LED DISPLAY shows 'OF' for 3
seconds, press Wireless button to turn on Wireless
function and the LED DISPLAY shows 'ON' for 3
seconds.
NOTE: When you restart the wireless function, it
may take a period of time to connect to the network
automatically.
Swing button(On some models)
(Applicable to the models with auto swing feature
only)
Used to initiate the Auto swing feature. When the
operation is ON, press the SWING button can stop the
louver at the desired angle.
Sleep(Eco)/Filter button
Used to initiate the SLEEP/ECO operation.
Operation
are for explanation purpose only. The control panel of the unit you
For 12000 Btu/h
15
NOTE: After 250 hours of operation, the filter
indicator light illuminates. This feature is a
reminder to clean the Air Filter for more
efficient operation. Press this button for 3
seconds to cancel the reminder.
Timer button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
with the + & - buttons. The timer on/off
indicator light illuminates under the timer
on/off settings.
Fan/Ion(On some models) button
Control the fan speed. Press to select the fan
(3s activate ion)
speed in four steps-LOW, MID(MED), HIGH
and AUTO. The fan speed indicator light
illuminates under different fan settings.
NOTE: Press this button for 3 seconds to
initiate ION feature. The ion generator is
energized and will help to remove pollen and
impurities from the air, and trap them in the
filter. Press it for 3 seconds again to stop the
ION feature.
Mode button
Selects the appropriate operating mode. Each
time you press the button, a mode is selected
in a sequence that goes from AUTO, COOL,
DRY, FAN and HEAT (cooling only models
without).The mode indicator light illuminates
under the different mode settings.