Trek LYNC Manuel Supplémentaire page 6

Riding with the Lync
This section explains the very easy operation
of the Lync lighting system.
Switching the lights off,
on, and flashing
The control panel has two buttons; the front
button is for the headlight, the rear button
is for the taillights. They control the light
functions. To switch to On or change the
mode, push a button. To switch to Off, hold
the button:
• Front: High, Low, and Off
• Rear: On, Flash, and Off
If you choose to use the control panel while
riding, be careful to maintain control of the
bike while your hand is off the handlebar.
Battery pack indicator light
When the battery charge is at 10% or lower,
the indicator light on the battery pack
(Figure 9) will show red. In addition, the
headlight will start a slow-blink pattern and
the taillights will flash.
Recharging the battery
This section explains about recharging the
battery on the Lync system.
For best results, recharge the battery at
room temperature. Recharging the battery
at extremes of temperature can result in less
than a full charge. Also avoid moisture when
recharging. It is best to do so inside your
home or office.
Trek Lync Owner's Manual Supplement | Riding with the Lync
6
All manuals and user guides at all-guides.com
FIGURE 9
Indicator light on battery
pack case
To recharge the battery
1. Remove the battery from the dock.
2. Plug your computer to a power source.
3. Connect the battery pack to the
computer with the supplied micro-USB
cord. To access the port on the battery
pack, lift the cover (Figure 11).
Alternately, connect the battery pack to
a wall charger with the micro-USB cord.
Note: There is no data exchanged with the
computer.
CAUTION: During charging, the
battery can get hot, reaching a
temperature of 40°C/104°F.
Time required
With a completely empty battery, it takes
about 6 hours to achieve a full charge.
When using a USB hub, charging may be
slow. In that case, connect the USB cable
directly to a computer's USB port or use a
USB wall charger.
Indicator lights while charging
While charging, the battery pack indicator
light is red. When the battery pack has a
full charge, the indicator light changes to
green.
FIGURE 10
Micro-USB cable
FIGURE 11
USB port cover on
underside of battery pack,
and connected to
micro-USB cable
Cover