Manfrotto Imagine More MVG220 Manuel D'instructions page 7

3
Camera Installation
Step 1: Mount quick release plate ① on
fixed plate ②, lock it. Loosen the ARCA
quick release plate safety lock ③, take
out ARCA quick release plate ④.
Step 3: Insert ARCA quick release plate
directly into quick release plate ① , tighten
③
the safety lock for ARCA quick release
plate.
All manuals and user guides at all-guides.com
⚠
Make sure the battery and memory
card are installed before camera
installation.
Step 2: Mount camera on ARCA
④
quick release plate .
⑤
Step 4: Install lens holder to
support lens, and tighten the thumb
screw.
5
5
5 5
4
Gimbal Balancing
TIPS
1) Before balancing the gimbal, please lock the gimbal at the balanced lock status.
2) Lens cover should be removed from the camera and the memory card needs to
be inserted to the camera to complete all the connections to ensure that the camera
is ready for shooting.
3) When balancing the gimbal, make sure the camera and gimbal are all powered
off.
4) If it is needed to add accessories after the balance is completed, gimbal needs to
be re-balanced again.
4.1 Balance Tilt Axis
(1) a. Unlock the tilt axis position lock ①, turn the camera lens upwards, and check the
gravity center of camera.
b. Loosen the sliding arm lock screw ②, slide the sliding arm
c. Tighten the sliding arm lock screw ②, when the camera lens keeps upwards that
means balanced.
7
GB
③ to balance the camera.