Publicité
Les langues disponibles
Les langues disponibles
6.
Connect 36 inch length of hose to
water inlet of pump.
7.
Add *RV antifreeze to hose as
shown.
8.
Pull engine starter rope slowly
several times until antifreeze
comes out of high pressure hose
connection of pump.
TROUBLESHOOTING GUIDE
PROBLEM
Engine will not
1.
start
2.
3.
4.
5.
No or low
1.
pressure
(initial use)
2.
3.
4.
5.
D28236
All manuals and user guides at all-guides.com
CAUSE
No fuel.
Pressure builds up after
two pulls on the recoil
starter or after initial use.
Choke lever in the "No
Choke" position.
Spark plug wire not
attached.
Choke lever in the
"Choke" position on a
"hot" engine or an engine
that has been exposed to
thermal heat for a long
period of time.
Wand not in high
pressure.
Low water supply.
Leak at high pressure
hose fitting.
Nozzle obstructed.
Water filter screen
clogged.
18- ENG
9.
Remove short hose from water
inlet of pump.
10. Reconnect spark plug wire.
* Windshield washer fluid may also be
used
CORRECTION
1.
Add Fuel.
2.
Squeeze gun trigger to
relieve pressure.
3.
Move choke to the
"Choke" position.
4.
Attach spark plug wire.
5.
Move choke to the "No
Choke" position.
1.
See How to Use Spray
Wand paragraph in the
Operation Section.
2.
Water supply must be at
least 5 GPM @ 20 PSI.
3.
Tighten. Apply sealant tape
if necessary.
4.
See Spray Wand
paragraph in the
Maintenance section for
the correct procedure.
5.
Remove and clean filter.
Publicité
