Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
7.
If you are applying a chemical or
cleaning solution, See How To
Siphon Chemicals/Cleaning
Solvents in Operation section of
this manual.
8.
Turn water source on.
NOTE: Failure to do so could cause
damage to the pump.
9.
TMove the choke control lever to
the CHOKE ON
the throttle control to the FAST
position. NOTE: No choke is
needed to start a warm engine.
Throttle
Control
10. Pull starter grip slowly until you
feel resistance, then pull briskly.
Return starter grip gently. Pull
rope with a rapid full arm stroke.
Let rope rewind slowly. Repeat if
necessary.
When performing maintenance, you may be exposed to hot
surfaces, water pressure, or moving parts that can cause
serious injury or death! Before performing any maintenance or repair,
disconnect spark plug wire, let engine cool and release all water pressure.
The engine contains flammable fuel. DO NOT smoke or work near open
flames while performing maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
frequent maintenance checks will be required.
pulls, pull the trigger to relieve the
pressure.
11. If the choke was used to start the
12. Depress trigger on gun to start
position and
13. Release trigger to stop water flow.
14. Adjust nozzle spray for the task
very hot engine muffler during or
immediately after use of your
Choke
pressure washer.
Control
MAINTENANCE
13- ENG
If the engine does
not start after two
engine, move the choke lever to
the OFF position.
water flow. NOTE: Stand on a
stable surface and grip
gun/spray wand firmly with both
hands. Expect the gun to kick
back when triggered.
being performed. See How To
Use Spray Wand instructions in
this section.
DO NOT let hoses
come in contact with
D28236
Publicité
