All manuals and user guides at all-guides.com
To Change Oil
Drain the engine oil when the engine is
warm. Warm oil drains quickly and
completely.
1.
Before tipping engine or
equipment to drain oil, drain fuel
from tank by running engine until
fuel tank is empty.
2.
Disconnect spark plug wire and
keep it away from spark plug.
3.
With engine OFF but still warm
remove filler cap/dipstick.
4.
Place a suitable container next the
engine to catch the used oil.
5.
Keeping air claner above oil outlet,
drain oil.
Air Cleaner
NOTE: Please dispose of used motor
oil in a manner that is compatible with
the environment. It is recommended to
take used oil in a sealed container to
your local recycling center or service
station for reclamation. Do not throw it
in the trash or pour it on the ground or
down a drain.
6.
With the engine in a level position,
fill to the FULL line on the dipstick
with SAE 10W-30 oil. Engine oil
capacity is 20 oz. (0.6 liter).
NOTE: Other viscosities shown in the
chart in the "To Check Oil" paragraph
may be used.
7.
Replace the oil filler cap/dipstick
securely.
Air Cleaner
To Remove
1.
2.
3.
4.
5.
Pre-
Cleaner
Drain Oil
To Clean
Separate pre-cleaner from cartridge
and wash in liquid detergent and water.
Air dry thoroughly. Do not oil.
Reassemble dry pre-cleaner on clean
cartridge.
Do not use pressurized air or solvents
to clean cartridge. Pressurized air can
damage cartridge; solvents will
dissolve cartridge.
Clean and Replace Spark Plug
Change the spark plug every 100 hours
of operation or once each year,
whichever comes first. This will help
your engine to start easier and run
better.
15- ENG
Loosen screw and tilt cover down.
Remove air cleaner.
Reinstall clean (or new) air cleaner
assembly inside cover. Lip of pre-
cleaner must be at bottom of
cartridge pleats.
Insert cover's tabs into slots in
bottom of base.
Tilt cover up into place and tighten
screw.
Cartridge Lip
Cartridge
Screw
Pre-Cleaner Lip
.030" (0.76 MM)
Wire Gauge
Resistor
Tabs
and
Slots
Base
Cover
D28236