Publicité
FCC information for the USA
FCC information for the USA
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment was tested for FCC compliance under conditions that include the use of shielded test leads between it and the peripherals. It is
important that you use shielded cables and connectors to reduce the possibility of causing Radio and Television interference. Shielded probes,
suitable for the VPS10 oscilloscope can be obtained from the authorized Velleman dealer.
If the user modifies the VPS10 oscilloscope or its connections in any way, and these modifications are not approved by Velleman, the FCC may
withdraw the user's right to operate the equipment.
The following booklet prepared by the Federal Communications Commission may be of help: "How to identify and Resolve Radio-TV
Interference problems". This booklet is available from the US Government Printing Office, Washington, DC20402 Stock No. 044-000-00345-4.
Important
This equipment was tested for FCC compliance under conditions that include the use of shielded test leads between it and the peripherals. It is
important that you use shielded cables and connectors to reduce the possibility of causing Radio and Television interference.
If the user modifies the VPS10 oscilloscope or its connections in any way, and these modifications are not approved by Velleman, the FCC may
withdraw the user's right to operate the equipment.
The following booklet prepared by the Federal Communications Commission may be of help: "How to identify and Resolve Radio-TV
Interference problems". This booklet is available from the US Government Printing Office, Washington, DC20402 Stock No. 044-000-00345-4.
2
All manuals and user guides at all-guides.com
VPS10 Panel Scope
TM
Publicité
