Publicité
VPS10 Panel Scope
Trigger gab
Fig 14
3
Fig 15
All manuals and user guides at all-guides.com
TM
1
Fig 16
Fig 17
2
Fig 18
SIGNAL SCREEN
X - position mode :
Press the 'MODE' button repeatedly until the 'X-pos'
setting appear.
•
Operating the 'Up' button will move the screen to the right
•
Operating the 'Down' button will move the screen to the left
Prolonged pressing will make the X-position change faster.
Notes:
A total of 256 samples are stored in memory, but the X-
size of the screen is limited. By shifting the X-direction
you can display all stored samples.
Y - position mode :
Press the 'MODE' button repeatedly until the 'Y-pos'
setting appear.
•
Operating the 'Up' button will move the displayed signal
upwards.
•
Operating the 'Down' button will move the displayed
signal downwards
Prolonged pressing will make the Y- position change faster. A
small dot (3) in the left-hand corner of the screen will indicate
the direction in which the signal has moved (Y pos).
In this manner, the user will know in which direction the
signal was going when it went off-screen. (Fig 15).
Signal screen
15
Publicité
