Aosom 370-233V80 Manuel D'assemblage Et D'instructions page 8

1. Remove a lock from the front axle with two spanners.
2. Place a Ø10 washer onto the front axle.
3. Slide the front axle through the hole on the right side of the front
fender, and out of the hole on the right side of the handlebar fork.
4. Place a Ø12 washer onto the front axle.
5. Place the front wheel onto the front axle.
6. Place a Ø12 washer onto the front axle.
7. Keep pushing the front axle, until it passes through the hole on the
left side of the handlebar fork, and out through the hole on the right
side of the front fender.
8. Place a Ø10 washer onto the front axle.
9. Tighten a locknut onto the end of the front Axle. Tip: An extra
spanner has been provided to hole the locknut, which is on the
other side of the front axle, while tightening the locknut on the
other side.
10. Fit the hub caps to both sides of the front fender.