1. Left front surface burner (9,100 BTUs) — XLO feature
on SGSX model only
2. Left rear surface burner (12,000 BTUs)
3. Center surface burner (16,000 BTUs — SGS model)
Center surface burner (18,000 BTUs — SGSL,SGSX
model) — XLO feature on SGSX model only
4. Right rear surface burner (9,100 BTUs)
5. Right front surface burner (12,000 BTUs)
6. Burner "On" Indicator Lights — "light ring" feature on
SGSL/SGSX models only
7. Serial Number/Data Plate Location (right front
underneath)
Sealed STAR™ Burners
Your new cooktop has sealed STAR™ gas burners. There
are no burner parts under the cooktop to clean,
disassemble or adjust. Your cooktop has three differen t
burner sizes; small, medium and large. Match the
corresponding letters on the burner cap and burner base.
See "Burners Caps" on page 7 .
STAR™ Burner Caps
The burner cap is porcelainized steel. The burner caps
must be properly placed for the cooktop to function
properly. If the burner cap is not properly placed, one or
more of the following problems may occur:
English 6
All manuals and user guides at all-guides.com
3
2
1
1
2
4
5
4
5
3
Figure 3: Model SGS3 65FS/SGSL365KS/SGSX365FS
•
Burner flames are too high.
•
Flames shoot out of burners.'
•
Burners do not ignite.
•
Burner flames light unevenly.
•
Burner emits gas odor.
WARNING:
To prevent flare-ups and avoid creation of
harmful by-products, do not use the cooktop
without all burner caps and all burner grates
properly positioned.
WARNING:
To prevent burns, do not touch burner caps or
grates while hot. Turn the cooktop off and allow
the burners to cool.
Placing Burner Caps
Each cap has a letter (B, D, or F) cast in the underside
the cap that corresponds to a lett er (B, D, or F) cast in the
burner base that is attached to the appliance.
•
Place each burner cap on its correct burner base per
its corresponding letter designation.
•
Place burner cap gently on top of base so that the
prongs of the burner base fit snugly into the groove of
the burner cap.
7
6
of