Publicité
Les langues disponibles
Les langues disponibles
Operation
Before first use
1. Clean the wine cooling drawer inside and out-
side for hygienic reasons (see chapter "Clean-
ing and maintenance" on page 18).
2. Fill the humidity tray with water at least until
the sponge is completely covered (fig. i,
page 10).
Saving energy
• Only open the wine cooling drawer as often and
for as long as necessary.
• Avoid unnecessarily low temperature settings.
• On a regular basis, make sure the drawer seal still
fits properly.
• Clean dust and dirt from the condenser at regu-
lar intervals.
Switching on and off
➤To switch on, press the
page 9).
➤To switch off, press and hold the
at least 2 seconds (fig. e, page 9).
Setting the temperature
To avoid food waste, note the following:
• Keep temperature fluctuation as low as possible.
Only open the wine cooling drawer as often and
for as long as necessary. Store the wine bottles in
such a way that the air can still circulate well.
• Adjust the temperature to the quantity and type
of the wine bottles.
The wine cooling drawer is set by default to a cool-
ing temperature of 11 °C (51 °F).
Troubleshooting
Fault
The device does not cool. Tempera-
ture indicator LEDs do not glow.
The device does not cool (plug is
inserted). Temperature indicator LEDs
glow.
EN
button once (fig. d,
button for
Possible cause
No voltage present in the AC
voltage socket.
The cooling element is defective. ➤ Contact authorized service agent
4445103702
➤To set the temperature, press the
repeatedly until you reach the desired tempera-
ture level (fig. f, page 9).
Using the presentation mode
With presentation mode activated the interior LED
lamp stays on permanently.
➤To activate and deactivate the presentation
mode, press simultaneously the
button for at least 2 seconds (fig. g,
the
page 10).
✔ All temperature indicator LEDs flash for 1 time.
Using the demo mode
With demo mode activated the compressor and
fans are switched off.
➤To activate the demo mode, press the
button for at least 6 seconds (fig. h,
page 10).
✔ All temperature indicator LEDs flash for 3 times.
✔ The temperature indicator LEDs for 11 °C (51 °F)
and 14 °C (57 °F) light up permanently.
➤To demonstrate the temperature setting func-
tion or the presentation mode, press the
button once.
✔ The temperature indicator LEDs for 11 °C (51 °F)
and 14 °C (57 °F) turn off within 2 seconds.
✔ The temperature indicator LED of the last
selected temperature level lights up.
➤To deactivate the demo mode, press the
button for at least 6 seconds (fig. h,
page 10).
✔ All temperature indicator LEDs flash for 3 times.
✔ The temperature indicator LED of the last
selected temperature level lights up.
Suggested remedy
➤ Try using another plug socket.
for repair.
button
button and
17
Publicité
