Publicité
Les langues disponibles
Les langues disponibles
Installation
Observe the following instructions when selecting
an installation location:
• Observe the product dimensions and the neces-
sary installation space to ensure a proper fit
(fig. 2, page 4, fig. 3, page 4).
• Observe the warnings when connecting the
supply cord (fig. 5, page 5).
• Ensure that the mounting surface is solid, level
and clean (fig. 6, page 6).
Preparing the cabinetry
See fig. 7, page 6
I
NOTE
For optimal efficiency install the wine
cooling drawer in a location with an
ambient temperature of 80 °F or less.
This will ensure that the wine cooling
drawer can reach and maintain the low-
est temperature setting.
1. Make a 2.4 x 7 inch cut-out in the left and right
corners of the back of the shelf.
2. Cut the short baffle sponge to an appropriate
size to fit the gap between the fan and the
back of the cabinetry.
3. Insert the baffle sponge between the fan and
the back of the cabinetry so that it fits tightly.
4. If the clearance between the top of the wine
cooling drawer and the cabinetry is larger than
0.4 inches, insert the long baffle sponge.
Cut the baffle sponge if necessary and put it
on top of the wine cooling drawer.
Mounting the wine cooling drawer
1. Attach the mounting plates to both sides of
the product housing using the supplied
screws and spacers.
Use a suitable combination of the spacers to
ensure a proper fit (fig. 8, page 7).
2. Plug in the supply cord.
3. Fully pull out the drawer and lift it off the slid-
ing rails (fig. 9, page 7).
16
4. Secure the product housing to the walls of the
cabinetry using the supplied screws and
washers (fig. 0, page 8).
5. Fully extend the sliding rails and carefully place
the drawer back onto the sliding rails (fig. a,
page 8).
6. Close the drawer.
Installing the overlay panel
(DrawBar5S only)
See fig. b, page 8
I
NOTE
Ensure that the measurements of the
overlay panel are suitable for the selected
installation location.
1. Install the cabinet handle on the overlay panel.
2. Pull out the drawer and remove the door
gasket to reveal the fastening holes.
3. Fasten the overlay panel to the drawer door
using the supplied screws.
4. Check for correct alignment after fastening
each screw.
5. Reattach the door gasket and close the
drawer.
Description of the device
No. in
fig. c,
page 9
1
2
3
4
5
6
7
4445103702
Explanation
Temperature indicator LEDs
On/off button
Setting button
Glass front panel with handle
(DrawBar5C only)
Humidity tray
Interior LED lamp
Rubber strips
EN
Publicité
