Harman Mark Levinson 526 Manuel Du Propriétaire page 7

GETTING STARTED
FRONT-PANEL OVERVIEW:
Input
Knob
input
headphones
Headphone
Output
Connector
Front-panel controls/indicators
Input knob: Rotate this knob to select the desired input to send
to the outputs. The name and volume level of the selected input
are indicated on the display. (Note: the Input knob will bypass
any input for which the Input Name Setup menu parameter has
been set to "Unused.")
IR receiver: the IR receiver receives commands from the
included remote control when the unit is not being controlled
via its rear-panel IR Input connector (see Rear-Panel Overview
for more information). Infrared communication requires line-
of-sight between the remote and this "target" on the unit's front
panel.
All manuals and user guides at all-guides.com
N 526 AND N 523
0 0
IR
Receiver
polarity setup enter
Setup Button
Polarity Button Enter
Button
display intensity balance mute
Balance
Button
Display Mute Button
Intensity
Button
Headphone output connector: this ¼-inch (6.3mm) TRS phone
plug connector provides a stereo signal that can directly drive
most headphones. When the unit detects that headphones have
been connected, the Balanced and Single-Ended outputs are
automatically muted, and the Volume knob switches to control
of the Headphone output level. When the unit detects the
headphones have been disconnected, the Balanced and Single-
Ended outputs are automatically unmuted, and the Volume
knob returns to control of their level.
The balanced and single-ended outputs can be configured in
the Setup menu as Fixed (for use with recording components
or a second audio zone). When outputs are configured as Fixed,
they are not affected by any of the front-panel controls.
N 526 / N 523 DUAL-MONAURAL PREAMPLIFIER
0 0
GETTING STARTED
Volume
Knob
volume
Standby
Button
/ OWNER'S MANUAL 5