Harman Mark Levinson 526 Manuel Du Propriétaire page 13

QUICK SETUP AND LISTEN
REMOTE CONTROL
Your remote control comes with two preinstalled AAA alkaline
batteries. To replace the batteries, remove the remote control's
battery cover using the included screwdriver, insert the batteries
and replace the battery cover. Be sure to observe proper battery
polarity.
When using the remote control, aim it toward the front-panel IR
receiver. Make sure that no objects, such as furniture, block the
remote's view of the receiver. Bright lights, fluorescent lights,
and plasma video displays may interfere with the function of the
remote.
• The remote has a range of about 17 feet (5m), depending on
the lighting conditions.
• You can use the remote at an angle of up to 45°.
• Placing the unit behind tinted glass will reduce the remote
control's effective range.
All manuals and user guides at all-guides.com
INITIAL CONNECTIONS
CAUTION: Before making connections, make sure the
preamplifier and all associated components are powered off
and disconnected from electrical outlets.
1. Connect your amplifier(s) to the preamplifier's output
2. Connect analog source components' outputs to the preamp's
3. (N
4. Connect the supplied power cable to the preamp's AC Mains
5. Press the front-panel Standby button or the Standby button
6. Turn the Input knob or press the Input buttons on the remote
7. Make sure the preamp's volume is set to a reasonable level.
N
0
connectors. Mark Levinson recommends using the Balanced
output connectors if your amplifier(s) have balanced input
connectors. Otherwise, use the Single-ended output
connectors.
analog audio inputs. Mark Levinson recommends using
Balanced connections whenever they are available.
526 only) Connect digital source components' outputs
0
to the preamp's digital audio inputs. If you are connecting
a computer via USB, download and install the USB driver
software from the product web page at marklevinson.com,
under the Downloads tab.
connector and into an electrical outlet. Turn the rear-panel
Power switch on the preamp to On, and turn on all associated
components.
on the remote control.
to select the input that corresponds to an input connector to
which you connected a source component.
It is best to start low and turn up to avoid unintentionally
damaging your equipment. Begin playing the selected source
device.
526 / N 523 DUAL-MONAURAL PREAMPLIFIER
0
QUICK SETUP AND LISTEN
/ OWNER'S MANUAL 11