Publicité
IMPORTANT
15.Apply grease evenly all around step spacer bushing
(C5) and in hole of aluminum disk (C1) when
assembling these parts together. See Fig. 25
Fig. 25
16.Slip steering limiter cable assembly over bolt (C3)
and use washer (C6) and nut (C7) to secure
assembly to anchor bracket. Tighten nut to 50 N•m
[37 lb•ft]. Refer to Fig. 26
NOTE: Make sure arrow on top of aluminum disk
points towards front of vehicle.
Fig. 26
STEERING LIMITER ADJUSTMENT
WARNING: Before going to the next steps,
make sure that stabilizing arms are correctly
installed, and that the angle of attack and
alignment are correct. Refer to the User
Manual supplied at purchase.
17.Turn the vehicle's steering wheel to its maximum
point of travel on the left. While maintaining
pressure on the steering wheel, turn threaded rod to
adjust length of cable so that the cable end hole (1)
is located 13 to 19 mm [½ to ¾ in.] short of the
mounting hole on the support plate (2). See Fig. 27
10
Fig. 27
Publicité
