Publicité
10.Position bottom part of anchor bracket (A1-A2)
assembly under front lower suspension arm, as
shown in the figure below. Position bracket cover
(A3-A4) over suspension arm and insert tenon,
located at the back, in mortise cut in bottom part.
Align holes in cover and bottom part. Insert
M10x65mm bolts (A5) through bottom and secure
the two parts together with nuts (A6) provided.
Tighten assembly to 50 N•m [37 lb•ft] of torque.
Refer to Fig. 21
Fig. 21
11. Using the wheel nuts (D) provided, secure
undercarriages to front wheel hubs. The procedure
and precautions are the same as for rear units.
Refer to Fig. 10
12.Attach the stabilizing rod (2) to the anchor bracket
(1), using the two spacer bushings (3), flat washer
(4) and nut (5). Torque to 70 N•m [52 lb•ft]. Refer to
Fig. 22
CAUTION: Components must be assembled in the
order shown.
13.Verify that spring assembly bolt (6) is tightened to
the recommended torque specification: 75 N•m [55
lb•ft]. Refer to Fig. 23
STEERING LIMITER INSTALLATION
14.Assemble steering limiter cables (C2), aluminum
disks (C1) and step spacers (C5) as shown on Fig.
24
9
Fig. 22
Fig. 23
Fig. 24
Publicité
