Publicité
10.Secure undercarriage to rear hub using the
provided lug nuts (D). See Fig. 10
CAUTION: If needed, take rubber protector off
of hub.
CAUTION: Follow torque specification indicated by
vehicle manufacturer when tightening wheel nuts.
Fig. 10
11. Attach stabilizing rod (2) to anchor bracket (1),
using bolt (B4), spacer bushings (B6 & 3), flat
washer (4) and nut (5). Torque to 70 N•m [52 lb•ft].
See Fig. 11
CAUTION: Components must be assembled in the
order shown.
Fig. 11
12.Verify that spring assembly bolt (6) is tightened to
the recommended torque specification: 75 N•m [55
lb•ft]. Refer to Fig. 12
13.Inspect the rear track systems and ensure that all
mounting bolts were correctly tightened during
installation. Lower the vehicle on the ground and
proceed to install the front track systems.
6
Fig. 12
Publicité
