Black & Decker BCW201 Mode D'emploi page 6

ENGLISH
approved safety equipment, such as those
dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from
power sanding, sawing, grinding, drilling,
and other construction activities. Wear
protective clothing and wash exposed
areas with soap and water. Allowing dust
to get into your mouth, eyes, or lay on
the skin may promote absorption of
harmful chemicals.
Warning: Use of this tool can
generate and/or disperse dust,
which may cause serious and
permanent respiratory or other injury.
Always use NIOSH/OSHA approved
respiratory protection appropriate for the
dust exposure. Direct particles away from
face and body.
Warning: Always wear proper
personal hearing protection that
conforms to ANSI S12.6 (S3.19)
during use. Under some conditions and
duration of use, noise from this product may
contribute to hearing loss.
Caution: When not in use, place tool
on its side on a stable surface where
it will not cause a tripping or falling
hazard. Some tools with large battery packs
will stand upright on the battery pack but
may be easily knocked over.
• Air vents often cover moving parts and
should be avoided. Loose clothes,
jewelry or long hair can be caught in
moving parts. If use of an extension cord
is absolutely necessary outdoors, use an
extension cord suitable for outdoor use.
Labels on tool
The label on your tool may include the
following symbols:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
The charger is intended for indoor
use only.
Read this entire manual carefully
before using the appliance.
6
(Original instructions)
Position of date barcode
The Date Code, which also includes the year
of manufacture, is printed into the housing.
Example:
2017 XX JN
Year of manufacturing
Electrical safety
Your charger is double insulated;
therefore no earth wire is required.
Always check that the mains voltage
corresponds to the voltage on the rating
plate. Never attempt to replace the charger
unit with a regular mains plug.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Batteries
The battery pack is not fully charged out of
the carton. Before using the battery pack,
read the safety instructions below and then
follow charging procedures outlined. When
ordering replacement battery packs, be sure
to include the catalog number and voltage.
Read all instructions
Important safety instructions for
all battery packs
Warning: Read all safety warnings
and all instructions for the battery
pack, and power tool. Failure to
follow the warnings and instructions may
result in electric shock, fire and/or serious
injury.
• Do not charge or use the battery pack in
explosive atmospheres, such as in the
presence of flammable liquids, gases or
dust. Inserting or removing the charging
cable from the battery pack may ignite
the dust or fumes.
• Never force the battery pack into cable
insertion or tool insertion. Do not modify
the battery pack in any way as battery
pack may rupture causing serious
personal injury.
• Do not splash or immerse in water or
other liquids.
• Do not store or use the tool and battery
pack in locations where the temperature