Black & Decker BCW201 Mode D'emploi page 14

ENGLISH
Note: Remove tool and both USB cables
from GoPak before cleaning.
Use only mild soap and a damp cloth to
clean the tool or power supply. Many
household cleaners contain chemicals which
could seriously damage plastic. Also, do not
use gasoline, turpentine, lacquer or paint
thinner, dry cleaning fluids or similar
products.
Troubleshooting
1. The GoPak will not power your device or
charge.
a. The LED closest to the state of charge
button will blink red when attempting
USB functionality.
- The GoPak is too hot or too cold. Allow
the GoPak to cool down or warm up.
2. The GoPak will not power your
compatible tool.
- Attempt to charge the battery. If the LED
fails to come on refer to number 1 in
Troubleshooting.
Repairs
The BLACK+DECKER GoPak 2 in 1 battery is
not serviceable.
Warning: To assure product SAFETY and
RELIABILITY, repairs, maintenance and
adjustment (including brush inspection and
replacement) should be performed by a
BLACK+DECKER factory service center or a
BLACK+DECKER authorized service center.
Always use identical replacement parts.
Technical data
Voltage
No-load speed
Oscillating angle
Sanding base surface Min
Weight
14
(Original instructions)
BCW201
V 12
DC
Min -1 11000 OPM
° 2.8
2 5078
kg 0.63
(with battery 0.88)
Level of sound pressure according to EN
60745:
Sound pressure(L
pA
uncertainty(K)3 dB(A)
Sound power(L ) 87,9 dB(A),
wA
uncertainty(K)3 dB(A)
Vibration total values (triax vector sum)
according to EN 60745:
Vibration emission value(handle) (a
2
m/s , uncertainty (K) 1.5 m/s
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for a
preliminary assessment of exposure.
Warning: The declared vibration
emission level represents the main
applications of the tool. However if
the tool is used for di erent
applications, with di erent
accessories or poorly maintained,
the vibration emission may di er.
This may significantly increase the
1.5exposure level over the total
working period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched o or when
it is running but not actually doing the job.
This may significantly reduce the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the e ects of
vibration such as: maintain the tool and the
accessories, keep the hands warm,
organisation of work patterns.
) 76,9 dB(A),
)4,7
h
2