Publicité
Les langues disponibles
Les langues disponibles
12 INSTALLATION
Reversing Doors
This feature is only available on some models.
Your appliance is designed with reversible doors
which can be assembled to open from either the
left or right hand side to suit your kitchen design.
NOTE
• Door reversal must be done by an authorized
installer or service person. If it is not, the doors
will not be covered by the warranty.
Connecting the Water Line
Before Beginning
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
If necessary, call a qualified plumber to correct
water hammer before installing the water supply
line to the refrigerator. Water banging in the pipes,
or water hammer in residential plumbing can
cause damage to refrigerator parts and lead to
water leakage or flooding.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
• Do not install the icemaker tubing in areas
where the ambient temperatures fall below
freezing.
WARNING
• Connect to potable water supply only.
CAUTION
• To prevent burns and product damage, only
connect the refrigerator water line to a cold
water supply.
• Wear eye protection during installation to
prevent injury.
All manuals and user guides at all-guides.com
Water Pressure
You will need a cold water supply.
If the water pressure from the reverse osmosis
system is less than 20 psi or 138 kPa or 1.4 kgf/
cm
oz or 198 cc capacity):
• Check to see if the sediment filter in the reverse
• Allow the storage tank on the reverse osmosis
• If the water pressure remains low, call a
• All installations must be in accordance with local
Supplies Needed
• Copper or PEX Tubing, ¼ in. outer diameter, to
• Power drill.
• ½ in. or adjustable wrench.
• Flat-blade and Phillips-head screwdrivers.
Water Pressure
20–120 psi
models with
water filter
(138 - 827 kPa)
where reverse
osmosis
40–60 psi minimum to reverse
water filtration
osmosis system (2.8 – 4.2 kgf/
system is
cm2,or less than 2–3 seconds to
connected to
fill a cup of 7 oz capacity)
a cold water
supply
(takes more than 4 seconds to fill a cup of 7
2
osmosis system is blocked. Replace the filter if
necessary.
system to refill after heavy usage.
licensed, qualified plumber.
plumbing code requirements.
connect the refrigerator to the water supply. Be
sure both ends of the tubing are cut square. To
determine how much tubing you need, measure
the distance from the water valve on the back of
the refrigerator to the water supply pipe. Then,
add 8 feet (2.4 m). Be sure there is sufficient
extra tubing (about 8 feet [2.4 m] coiled into 3
turns of about 10 in. [25 cm] diameter) to allow
the refrigerator to move out from the wall after
installation.
Publicité
