Husqvarna 572 XP Manuel D'utilisation page 35

Recommended cutting equipment
A specific chainsaw model has to be evaluated with
the cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw models Husqvarna 565, 572 XP, 572 XPG
met the safety requirements in ANSI B175.1-2012
and Canadian Standards Association CSA Z62.1-15
(Chainsaws) and CSA Z62.3-11 (R2016) (Chainsaw
kickback), when equipped with the below listed saw
chain and guide bar combination(s).
Approved cutting equipment for Husqvarna 565, 572 XP, 572 XPG
Guide bar
Length, in Pitch, in
15 3/8
16
18
20
24
28
15 3/8
16
18
20
24
28
15 3/8
16
18
20
24
28
140 - 011 - 11.05.2023
Accessories
Note:
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Gauge, in Max. nose radius
0.058 11T
11T or 34 mm
0.058 11T
11T or 34 mm
0.058 11T
11T or 34 mm
Other chainsaw models may not meet the
Saw chain
Type
Husqvarna H42
Husqvarna C85
Husqvarna H47
Husqvarna H46
Husqvarna H48
Husqvarna C83
Husqvarna S85
Length, drive
links (no.)
56
60
68
72
84
92
56
60
68
72
84
92
56
60
68
72
84
92
35