Husqvarna 572 XP Manuel D'utilisation page 21

5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension.
WARNING:
through a tree or branch that is in
tension.
WARNING:
you cut a tree that is in tension. There is
a risk that the tree moves quickly before
or after you cut it. Serious injury can
occur if you are in an incorrect position
or if you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION:
cause operation problems. Risk of too low
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
140 - 011 - 11.05.2023
Do not cut straight
Be very careful when
Snow and cold weather can
Maintenance
Read and understand the
engine temperature or ice on the air filter
and the carburetor.
• For temperatures below -5°C/23°F or in conditions
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space.
Note:
Part number for winter cover: 575 52 75-01
CAUTION:
cover if the temperature increases above
-5°C/23°F. Risk of too high engine
temperature and damage to the engine.
Heated handles (572XPG)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Electrical carburetor heating (572XPG)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.
Remove the winter
21