Door Chime Options; Zone Input/Pgm Output Option - DSC LCD5511 Instructions D'installation

Door Chime Options

You can program the LCD5511 keypad
to sound a tone when any zone is opened
or closed. There are two parts to the
LCD5511 door chime programming:
• Program if the LCD5511 will chime
when zones are opened and/or
closed.
• Program the type of sound the
LCD5511 will make when an individual
zone is opened or closed.
For the door chime feature to work, you
will also need to turn on the Door Chime
attribute for each zone that will trigger the
chime. This programming is done in the
control panel software. Refer to your con-
trol panel's Installation Manual for more
information.
Door Chime on Zone Openings/Closings
You can program each LCD5511 keypad
to sound a door chime when zones are
opened and/or when they are closed. By
default, LCD5511 keypads are pro-
grammed to sound door chimes on both
zone openings and closings.
To change the door chime opening/clos-
ing settings, at each LCD5511 keypad:
✱
1. Enter [ ][8][Installer's Code]
2. Enter [000] to go to keypad program-
ming
3. Enter section [6].
4. To turn the options on or off, press [6]
or [7]:
[6]ON =Door Chime Enabled for Zone
Openings
OFF =Door Chime Disabled for Zone
Openings
[7]ON =Door Chime Enabled for Zone
Closings
OFF =Door Chime Disabled for Zone
Closings
5. When you are finished, press [#] to exit.
Door Chime Sounds
You can program the LCD5511 keypad
to make different door chime sounds for
individual zones, or groups of zones.
Each LCD5511 keypad can make any of
four door chime sounds for each zone
that triggers the door chime:
• 4 quick beeps (default sound)
• 'Bing – Bing' tone
• 'Ding – Dong' tone
• 'Alarm' tone
NOTE: For a zone to be able to trigger the
door chime sound, the Door Chime zone at-
tribute must also be enabled in the control pan-
el programming. Please see your control panel
Installation Manual.
To change the door chime sounds:
✱
1. Enter [ ][8][Installer's code].
✱
2. Enter [ ] to go to door chime sound
programming.
3. Enter a 2-digit number for the zone
you want to program [01] - [64].
4. Turn one of the following options on by
pressing [1], [2], [3], or [4]:
[1] 4 quick beeps (default sound)
[2] 'Bing – Bing' tone
[3] 'Ding – Dong' tone
[4] 'Alarm' tone
NOTE: Make sure that only one of the above
options is turned on. If more than one is on,
the keypad will sound the first option that is
enabled. If none of the options are selected, the
keypad will not make any sound when the zone
is opened or closed.
5. To program the door chime sound for
another zone, repeat steps 3 and 4.
6. When you are finished programming
the door chime sounds, press [#] to
exit.

Zone Input/PGM Output Option

The LCD5511 'Z/P' terminal can be pro-
grammed to support one zone input (de-
fault) or one PGM output. To change this
option:
✱
1. Enter [ ][8] [Installer Code].
2. Enter [000] to go to keypad program-
ming.
3. Enter section [6].
4. Turn the option on or off by pressing
[8].
4