EGO HTX5300-PA Guide D'utilisation page 40

TRANSMISSION GEARS
LUBRICATION
The transmission gears in the cutting
head and power head assemblies need
to be lubricated periodically with gear
grease. Check the gear case grease level
approximately every 50 hours of operation
by removing the sealing bolts. There are
five sealing bolts: four on the cutting head
assembly (Fig. 16a & 16b) and one on the
power head assembly (Fig. 16c).
If no grease can be seen on the flanks
of the gear, follow the steps below to fill
with gear grease to 3/4 capacity. Do not
completely fill the transmission gear case.
1. Depending on which bolt you are
removing, lay the hedge trimmer on its
back or hold it on its side so that the
sealing bolt to be removed is facing
upwards.
2. For the sealing bolts 1 – 4, use a
5 mm hex key (not included) to loosen
and remove the sealing bolt; for the
sealing bolt 5, use the included hex key
to loosen and remove the bolt.
3. Use a grease gun (not included) to
inject some grease into the bolt hole;
do not exceed 3/4 capacity.
4. Tighten the sealing bolts after injection.
WARNING:
it may result in injury to the user. Please be sure to secure it in place before using the
machine.
40
56-VOLT LITHIUM-ION COMMERCIAL 21" ARTICULATING POLE HEDGE TRIMMER — HTX5300-PA/HTX5300-PA-FC
The sealing bolt 4 shall not be lost. Operation of the machine without
16a
Cutting Head Assembly
Sealing Bolt 2
Sealing Bolt 1
16b
Cutting Head Assembly
Sealing Bolt 3
16c
Power Head Assembly
Sealing Bolt 4
Sealing Bolt 5