EGO HTX5300-PA Guide D'utilisation page 13

 Do not grasp the exposed cutting blades or cutting edges when picking up or
holding the hedge trimmer.
 Do not use on a ladder, rooftop, tree, or other unstable support. Stable footing on
a solid surface enables better control of the hedge trimmer in unexpected situations.
 Never allow children to operate the hedge trimmer.
 Never remove or tamper with safety devices. Check their proper operation
regularly. Never do anything to interfere with the intended function of a safety
device or to reduce the protection provided by a safety device.
 Never operate the hedge trimmer without proper guards, plates, or other safety
protective devices in place.
 Check damaged parts before further use of the hedge trimmer. A guard or
other part that is damaged should be carefully checked to determine that it
will operate properly and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and
any other condition that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced by an authorized service center
unless indicated elsewhere in this manual.
 Check the blade and motor mounting bolts at frequent intervals for proper
tightness. Also, visually inspect blade for damage (e.g., bent, cracked, and
worn). Replace the blade only with an EGO™ blade. An unbalanced blade causes
vibration that could damage the motor drive unit or cause personal injury.
 Replace the blade if it is bent or cracked. An unbalanced blade causes vibration
that could damage the motor drive unit or cause personal injury.
 If the equipment should start to vibrate abnormally, stop the motor and check
immediately for the cause. Vibration is generally a warning of trouble.
 The hedge trimmer shall be used to cut stems less than 1.1 in. (28 mm) thick.
 Trim only in daylight or in good artificial light.
 Remove or disconnect battery before servicing, cleaning, or removing material
from the hedge trimmer.
 Do not wash with a hose; avoid getting water in motor and electrical
connections.
 When servicing use only identical replacement parts listed in this manual.
Use of parts which do not meet the original equipment specifications may lead to
improper performance and compromised safety.
56-VOLT LITHIUM-ION COMMERCIAL 21" ARTICULATING POLE HEDGE TRIMMER — HTX5300-PA/HTX5300-PA-FC
13