Publicité
Les langues disponibles
Les langues disponibles
About Thermal Fuses
• Your 12 volt battery is equipped with a built-in thermal fuse. The
thermal fuse is a self-resetting safety device which automatically
trips and shuts down operation of the vehicle if the vehicle is
overloaded or the driving conditions too severe. Once a fuse has
tripped, it will automatically reset itself after approximately 10
seconds and allow the vehicle to resume normal operations. To
avoid repeated automatic shut downs, do not overload the vehicle
by exceeding the 88 lbs (40kg) maximum weight capacity or by
towing anything behind the vehicle. Avoid severe driving conditions,
such as driving up very steep slopes or running into fixed objects,
which can cause the wheels to stop spinning while power is still
being supplied to the motors.
Important Notes
• Your new battery must be charged for at least 12 hours before you
use it in your vehicle for the first time.
• You do not need to remove the battery from your vehicle to
recharge it.
• The battery must be upright while charging.
• The charger is not a toy.
• Do not short circuit the battery.
• We recommend that you start charging your battery before
beginning assembly of your new vehicle.
• Before charging the battery, examine the battery case for cracks
and other damage which may cause sulfuric acid (electrolyte) to leak
during the charging process.
• If damage is detected, do not charge the battery or use it in your
vehicle. Battery acid is very corrosive and can cause severe
damage to surfaces It contacts.
• Do not charge the battery on a surface which could be damaged by
the acid contained inside the battery. Take precautions to protect the
surface on which you charge your battery.
• If your battery is old and will not accept a charge, do not leave it in
the vehicle. Always remove a dead battery from the vehicle.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
08
Battery Charging
CAUTION
• Non-rechargeable batteries are not to be recharged.
• Make sure the charger connector is matching with the battery
connector.
• Make sure the brand, voltage and frequency of the charger are in
accordance with the wall outlet.
• Batteries are to be Inserted with the correct polarity.
• The supply terminals are not to be short circuited.
Charge the Battery
The first charge will take about 12 hours.
Tips 1:
1. Open the battery charger port (located on the
seat of near by).
2. Insert the battery charger connector into the
charger port.
3. Plug the charger into a standard 120V or
230V wall outlet. Note:The charger may feel
warm during charging. This is normal and not a
cause for concern.
4. After charging is complete (at least 8-10
hours, but not more than 24 hours, with the first
charge taking about 12 hours), unplug the
charger from the wall outlet and unplug the
battery connector from the charger port.
Tips 2:Charge the
battery separately
Take out the battery
Charge the battery
same as tips 1.
09
Publicité
