Publicité
Les langues disponibles
Les langues disponibles
Drive Belt
Check Drive Belt Condition
Replace the drive belt if it is cracked or has broken teeth or frayed edges. No matter its condition, the drive belt
should be replaced at periodic intervals (see the VICTORY Service Manual or an authorized VICTORY dealer).
NOT attempt to check belt tension if the belt has been exposed to rain or washing within a 24 hour period or if the belt is hot
from riding. Allow the belt to cool down to ambient temperature before measuring belt tension.
Check Drive Belt Tension
This procedure involves using the belt tension gauge, part no. PV-43532,
which is designed specifically for measuring drive belt tension.
Before beginning this procedure:
S Make sure the drive belt is dry and at room temperature.
S Make sure the rear suspension is properly adjusted (see Adjust Rear
Shock Absorber, page 93).
1. Place the transmission in Neutral and lift the rear wheel off the ground
with an appropriate motorcycle lift or a block of wood or steel placed
securely under the frame.
WARNING
Care should be taken to be sure the motorcycle will not tip or fall while elevated. Severe personal
injury or death may occur if the motorcycle tips or falls.
All manuals and user guides at all-guides.com
MAINTENANCE
DO
3
1. Belt Tension Gauge
1
2. Small O-Ring
3. Base
4. Plunger
2
4
87
Publicité
