Publicité
@q
,/+
~
e~ ,.
-..'.
..
,:
..',-.. ; .
-,'
,.
..,',..
. .
)
d
-%
'+! /
PRECAUTIONS
Follow the advice below for safe and correct
operation.
This system
may be powered
by an AC voltage
or car battery
(DC 12 V) power source.
(Car battery cord is not supplied.)
On AC voltage
Before
connecting
the AC cord, check
that the rated voltage
shown on the rear panel matches
your local voltage.
For LH model
AC 120/220-240
V, selectable.
To match your local voltage,
switch the AC VOLTAGE
selector
on the rear panel with a screwdriver
or similar tool. +
For U model
AC 120 V, fixed,
For K model
AC 230 V, fixed.
On
placement
Do not use the system in places which are extremely
hot, cold,
dusty or humid.
Do not use the system in places which are subject to vibration.
Place the system
on a flat, even surface.
The unit should be situated
with adequate
space around
it so
that proper
heat ventilation
is assured.
Allow
10 cm (4 in.)
clearance
from the rear and the top of the unit, and 5 cm (2 in.)
from each side.
In particular,
do not place the system
in an airtight
rack.
If using the system
near a television
or radio, noise may be
heard from the television,
radio or this system. Move this system
away from the affected
television
or radio.
On safety
When disconnecting
the AC cord or car battery cord, pull out
by the plug.
Do not pull the cord itself.
When the system
is not used for an extended
period of time,
disconnect
the AC cord or car battery cord. When the cord is
plugged
in, a small amount
of current
continues
to flow to the
system,
even when the power is turned off.
If the AC cord is damaged,
contact
your dealer
or an Aiwa
service
center for immediate
replacement
or repair.
Should any trouble occur, disconnect
the AC cord and car battery
cord and contact
a qualified
service
representative.
CONNECTIONS
IMPORTANT
.
Make sure the AC voltage
matches
your local voltage.
(LH
model only)
Connect
the AC cord or car battery
cord after
connecting
speakers,
antennas,
and all optional
equipment.
There are no differences
between the speakers.
Both speakers
can be connected
as L (left) or R (right).
To stand the AM antenna + H
Fix
the claw to the slot,
To position the antennas
FM feeder antenna: (For U and LH model only)
Extend this antenna
horizontally
in a T-shape
and fix its ends to
the wall with cellophane
tape, etc.
FM unipolar antenna: (For K model only)
Extend fully and position
for the best possible
reception.
This antenna
is of an instant
type,
so the use of an outdoor
antenna
is recommended.
AM (MW/LW)
loop
antenna:
Position to find the best direction and position for radio reception.
8
Publicité
