Télécharger Imprimer la page

Aiwa LCX-300 Mode D'emploi page 14

Masquer les pouces Voir aussi pour LCX-300:

Publicité

2 144
DOWN
UP W
144 DOWN UP -
w
b
SETTING THE CLOCK
When the AC cord is just connected,
the clock display
flashes.
Set
the time as follows while the power is off.
1
2
3
4
5
Press the II SET button.
The hour flashes.
Press
the W
DOWN
or UP M
button
to
designate the hour.
Press the II SET button to set the hour.
The hour stops flashing
and the minute starts flashing.
Press
the W
DOWN
or UP M
button
to
designate the minute.
Press the II SET button to set the minute and
complete setting.
The minute stops flashing
on the display and the clock starts
from 00 second.
To
correct the current time
Press the POWER
button to turn the unit off.
Press the II SET
button, the clock display flashes and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK
button
while pressing
the SHIFT
button
on
the remote control.
The clock is displayed
for 4 seconds.
However,
the time cannot be displayed
during recording.
To switch to the 24-hour standard
Press the CLOCK
button
while pressing
the SHIFT
button
on
the remote control and then press the
button within 4 seconds.
Repeat the same procedure
to restore the 12-hour standard.
if the clock display flashes while the power is off
This is caused
by a power interruption.
The current time needs
to be reset.
If power is interrupted
for more than approximately
24 hours, all
settings
stored in memory
after purchase
need to be reset.
14

Publicité

loading

Ce manuel est également adapté pour:

Lcx-301