Publicité
BAND
TU
\ER
1
MANUAL TUNING
1
2
Press the TUNEF?IBAND button to select the band
repeatedly.
U and LH models:
~M~AM
K model:
rFM~Mw
—--+LW1
If the power was off, the previously
tuned station will be played
(Direct Play Function).
When using the remote control
Press the BAND button.
Press the K
DOWN or UP W
button to select
a station.
Each time the button is pressed,
the frequency
changes.
When a station is received, "TUNE
is displayed for 2 seconds.
During FM stereo reception,
"STEREO"
is displayed.
To
search for a station quickly (Auto Search)
Keep the W
DOWN or UP H
button pressed
until the tuner
starts searching
for a station.
After tuning
in to a station,
the
search stops.
To stop the Auto Search manually,
press the W
DOWN or UP
W
button.
The Auto
Search
may not stop at stations
with very weak
signals.
When an
FM stereo broadcast contains
noise
Press the MODE TUNER button while pressing the SHIFT button
on the remote control to display "MONO.
+
Noise is reduced,
although
reception
is monaural.
To restore stereo
reception,
press the buttons
so that "MONO
disappears,
To
change the AM (MW) tuning interval
The AM (MW) tuning interval can be set to 9 kHz/step
or 10 kHz/
step. The default setting are shown below.
U and LH models:
10 kHz
K model:
9 kHz
If you use this unit in an area where
the frequency
allocation
system is different from the default one, change the tuning interval
as follows.
Press the POWER
button while pressing
the +-
button.
To reset the interval,
repeat this procedure.
When
the AM (MW) tuning
interval
is changed,
all preset
stations
(see page 20) are cleared.
The preset stations
have
to be set again.
18
Publicité
