Télécharger Imprimer la page

Pit Boss SILVER STAR 3 Serie Instructions Et Recettes page 9

Publicité

Les langues disponibles

Les langues disponibles

7. MOUNTING THE POWER CORD BRACKET
Parts Required:
1
x
Power Cord Bracket (#19)
2
x
#10–24x½" Screw (#C)
Installation:
Loosen the screw of the power cord clip on the support leg, and guide
the power cord through the power cord clip to secure.
Locate the two holes on the bottom of the (left side) support bracket.
Mount the power cord bracket to the support panel using two screws
as shown in illustration 7A. Once secure, wrap the power cord on the
bracket until unit is in use.
Proceed to fully-tighten all screws on the cabinet base, then carefully
turn the cart upright with the wheels on the bottom. Note 7B.
IMPORTANT: Ensure that all screws on the cabinet base are fully-
tighten to avoid screws falling out when the unit is moved.
8. INSTALLING THE DAMPERS INTO THE MAIN CABINET
Parts Required:
Main Cabinet (#9)
1
x
2
x
Damper Vent (#3)
2
x
#10–24x½" Screw (#C)
2
x
#10-24 Lock Nut (#D)
2
x
M5 Locking Washer (#E)
Installation:
First, lift the main cabinet door off the hinges, and place aside. Note 8A.
Place one screw from the outside of the main cabinet into the center
of each damper. Next, insert a damper inside the main cabinet with
the raised tab facing the rear, and secure the screw from the exterior
using a locking washer and lock nut. Repeat same installation for
second damper, as shown in illustration 8B.
9. MOUNTING THE BACK HANDLE
Parts Required:
Back Handle (#4)
1
x
¼–20x⅝" Screw (#A)
4
x
Installation:
Mount the handle onto the back side of the main cabinet using four
screws. Note correct position as shown, with handle on top.
7A
7B
8A
8
8B
9
4
19
9
3
3
9

Publicité

loading

Ce manuel est également adapté pour:

Pbv3du177235