Items Included; Assembly; Settings - Festool STM 1800 Notice D'utilisation D'origine

Mobile saw table and
work bench
Table height (adjust­
able)
Max. load
Max. workpiece dimen­
sions
(Tilting function)
Weight
5

Items included

[1-1] Folded mobile saw table and work
bench
[1-2] Assembly accessories
[A] 4x M6 screws with nuts
[B] 4x M10 hexagon socket screws
with washers
[C] 12x wood screws with cross recess
(PZ 1 3x16)
[1-3] 4x attachable tubes
[1-4] 4x wooden supports for fitting to the
attachable tubes
[1-5] 5x pre-assembled wooden supports
incl. clips
[1-6] 4x permanently fitted wooden supports
[1-7] 4x wheels
[1-8] 2x roller housings with brakes
[1-9] 2x roller housings without brakes
The illustrations specified are located at the
beginning and end of the operating instructions.
6

Assembly

6.1 Fitting the wooden supports to the
attachable tubes
► Screw the wooden support [2-2] to the
attachable tube [2-1] with the screws [C].
► Fit the four wooden supports in this
manner.
6.2 Fitting the wheels
Pay attention to the side of the
premounted foot end caps.
Fit the wheels with brake to the side of the
foot end caps (Fig. 3A).
Fit the wheels without brake to the oppo­
site side of the foot end caps (Fig. 3B).
STM 1800
700–900 mm
150 kg
3100 x 2150 mm
34 kg
► Screw the roller housing with hexagon
socket screw and washer [B] to the base
tube.
► Insert the wheel into the roller housing.
► Secure the wheel to the roller housing
with a screw and nut [A].
► Fit the two wheels with brakes and the two
wheels without brakes in this manner.
6.3 Unfolding the mobile saw table and
work bench
Open the transportation lock [4-1].
►
► Opposite the foot end caps: Pull apart
the folding frame [4-5] until the locking
bolt [4-2] locks into place.
► Side of the foot end caps: Pull out the
locking bolt [4-3] and pull apart the folding
frame [4-5] by pushing the central rod [4-4]
until the locking bolt [4-3] locks into place.
6.4 Fit the central wooden support incl.
clips
► Clamp the wooden support premounted on
clips [5-1] to the central tube of the folding
frame [5-2].
The mobile saw table and work bench is ready
for use.
7

Settings

7.1 Adjusting the working height
The working height can be adjusted in incre­
ments of 50 mm between 700 mm and 900 mm.
► Loosen the locking knob [6-3], pull it out
and keep it pulled out.
► Extend or insert the base tube [6-2] and
lock it into one of the locking holes [6-1].
► Release the locking knob [6-3] and tighten
it.
► Set the four base tubes to the same height
in this manner.
7.2 Adjusting the brakes
Locking the brakes
► Press down on the brake lever [7-1] until
the brake fixture locks into place [7-2].
Releasing the brakes
► Press the brake lever [7-1] upwards until
the brake fixture [7-2] is released.
7.3 Extending the work surface
The work surface can be adjusted to the
maximum dimensions of 1800 x 2100 mm.
Fitting the attachable tubes
► Release the rotary knob [8-2].
English
11