Fein Slugger JMC MAGFORCE 90 Mode D'emploi page 25

Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools, coolant container, contact
protector
When the power tools's power supply cable
is damaged, it must be replaced using a spe-
cially prepaired power supply cable, avail-
able from your FEIN customer service agent.
Products that have come into contact with
asbestos may not be sent in for repair. Dis-
pose of products contaminated with asbes-
tos according to the applicable country-
specific regulations for such disposal.
For FEIN power tools and accessories in
need of repair, please contact your FEIN
after-sales service. The address can be found
on the Internet under www.fein.com.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Use only original spare parts.
Service.
Have maintenance carried
WARNING
out only through qualified
personnel. Incorrectly mounted leads and
components can cause serious injuries.
Have the required service carried out only
through a FEIN customer service agent.
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed.
Environmental protection, disposal.
Sort scrapped power tools and accessories for environmental-friendly recycling. For further
information, please contact your specialist shop.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the
power tool from the power supply in order to
avoid accidents.
When using in environments
WARNING
with conductive dust in the
air, such as when working metals, this dust
can settle in the interior of the power tool.
This can impair the total insulation of the
power tool. Therefore, regularly blow out the
interior of the power tool from outside via
the ventilation openings with dry, oil-free
compressed air; always wear eye protection
when doing this. For additional protection,
connect a residual current device (RCD) on
the line side.
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon-tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.
en
25