Publicité
Les langues disponibles
Les langues disponibles
5454510-KappundGeh-man.qxd
clockwise and tightened by turning it
anticlockwise.
Using the socket spanner (9), undo saw
blade retaining screw, remove flange
disk (18) and change the saw blade
(Fig. 2). Reassemble in reverse order.
Adjusting the tilt stop
To enable the saw to be set precisely at
right angle or at an angle of 45° in both
fence positions, the tilt stop must be
adjusted:
1. Fold down saw and fasten with the
locking pin (8).
2. Loosen twist-knob of the horizontal
mitre setting (6) for tilt setting on the
back of the saw.
3. Align saw blade at a 90° angle precisely
at right angles to the turntable (Fig. 3).
Check settings on the mitre scale (19).
Loosen screw (a) and set the arrow
mark (b) to the 0°/90° point on the
mitre scale. Retighten the screw (a)
firmly (Fig. 4).
4. If necessary, loosen locknut of the 90°
adjusting screw (15) and adjust the
fence screw so that the saw is up
against the fence screw at an angle
of exactly 90°. Re-tighten the counter
nut.
5. Carry out steps three and four on the
45° adjusting screw correspondingly
for an angle of 45° (Fig. 5).
Setting the cut angle
ATTENTION! Switch off appliance
and pull out mains plug.
For maximum material dimensions for
each angle setting, see Fig. 6.
All manuals and user guides at all-guides.com
26.02.2009 16:33 Uhr
Seite 63
Vertical mitre cuts 45°-90°/0°
Release cutting angle lock (5) by turning it
anticlockwise and set the desired cutting
angle by using the handle (1) to swivel the
machine. Cutting angles are locked in 5°
steps. Intermediate values can be set
with the aid of the mitre scale. To lock,
turn cutting angle lock clockwise.
Horizontal mitre cuts 45°-90°/0°
Release twist knob (6) on rear of the
appliance. Swing saw head about its
horizontal axis to the required cut angle
(graduation). Retighten the twist knob
firmly.
8 – Operation
ATTENTION! The appliance may
be operated only in a dry, well-lit
environment.
For safe work, bolt the machine onto a
stable base, work bench or table through
the bolt holes (11). Pull out locking pin (8)
and allow the saw head (12) to slide up
into its starting position. Press workpiece
firmly against the workpiece fence (4).
Clamp large and small workpieces, e.g.
with a screw clamp. Wait for the appliance
to come to a standstill before removing
workpiece from the saw bench (3).
Switching on
Press and hold down On/Off button (1).
Allow appliance to reach maximum
speed. Press locking lever (2) and feed
the saw head (12) slowly onto the
workpiece. Press lightly when sawing.
Stopping
Release On/Off switch and allow the saw
head to move into its starting position.
63
Publicité
