Cutting Attachment; Safety Instructions For Assembly; Safety Instructions For Maintenance - Husqvarna 535iFR Manuel D'utilisation

Masquer les pouces Voir aussi pour 535iFR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

is shielded by the blade guard when you
do this.
Note: Make sure that you can not turn the locknut by
hand. Replace the nut if the nylon lining does not have a
resistance of a minimum of 1.5 Nm. The nut should be
replaced after it has been put on approximately 10
times.

Cutting attachment

WARNING: Remove the battery and make
sure that the cutting attachment stops
completely before you work on any part of
the cutting attachment.
WARNING: Use correct cutting attachment.
Only use the cutting attachment with the
guards we recommend, refer to
on page 29 . Make sure that the cutting
attachment is sharpened correctly. A cutting
attachment that is not sharpened correctly
increases the risk of blade thrust.
WARNING: An incorrectly sharpened or
damaged blade increases the risk of
accidents. Keep the teeth of the blade
correctly sharpened. Follow the instructions
and use the recommended file gauge.
WARNING: A coasting blade can cause
injury while it continues to spin after the
switch has been released. Need to maintain
proper control until the blade has completely
stopped rotating.
CAUTION: An incorrectly set saw blade
increases the risk of jamming and blade
thrust. This can damage the saw blade.
Keep the correct setting on the saw blade.
Follow the instructions and use the
recommended setting tool.
Wear protective gloves when the cutting attachment is
handled.
Use the saw blade to cut fibrous types of wood.
Use the blades and grass knives to cut coarse grass.
Use the trimmer head to trim grass.
Check the cutting attachment for damage or cracks.
Replace a damaged cutting attachment.
609 - 003 - 11.12.2019
Trimmer head
Always use the correct trimmer head, cutting
attachments and always use the recommended
trimmer line. Refer to
the assembly in the end of the Manual.
Make sure that the cutter on the trimmer guard is not
damaged.
Make sure that the trimmer line is wound tightly and
equally around the drum to prevent unusual
vibrations from the product. Different cord lengths
can result in vibrations that are not necessary. Tap
the trimmer head to get correct length on the cord.
To increase the life of the cord it can be soaked in water
for 2 days or more before assembly. This will make the
cord more resistant.
Saw blade and grass blade
Use correctly sharpened blades. An incorrectly
Accessories
sharpened or damaged blade increases the risk of
injury.
Use correctly set blades. Correct blade set is 1 mm.
An incorrectly set blade increases the risk of injury
and damage.
To sharpen and set the blade correctly, refer to the
instructions that come with the blade.

Safety instructions for assembly

Remove the battery from the product before you
assemble the product.
Use approved protective gloves.
When you use a saw blade or a grass blade, make
sure that the correct handlebar, the blade guard and
the harness are attached to the product.
A defective or incorrect guard can cause injury. Do
not use a cutting attachment that does not have an
approved guard attached.
Make sure that you assemble the cover and shaft
correct before you start the product.
The drive disc and support flange must engage
correctly in the centre hole of the cutting attachment.
A cutting attachment that is attached incorrectly can
cause injury or death.
To operate the product safely and prevent injury to
the operator or other persons, the product must
always be attached correctly to the harness.

Safety instructions for maintenance

Accessories on page 29 and
WARNING: Read, understand and obey
these instructions carefully before you use
the product.
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

535irxt535irx

Table des Matières