Cutting Attachment Guard - Husqvarna 536LiLX Manuel D'utilisation

• it is not possible to apply full power and, at the same
time, activate the machine. Release the power trigger
and the machine is active.
• the machine is blocked. Deactivate the machine.
Disconnect the battery. Remove the grass or other
material that is wrapped around the trimmer head.
• the machine is overloaded due to heavy trimming.
Release the power trigger and the machine is active.
If the warning symbol (3) flashes, it indicates that the
machine is too hot and the machine deactivates. When
the machine is restored to normal temperature it is again
ready to run.
Solid light indicates service.
Power trigger lockout
The power trigger lockout is designed to prevent
accidental activation of the throttle.
When you press the power trigger lockout (1) into the
handle it releases the power trigger (2). When you release
the handle the power trigger and the power trigger lockout
both move back to their original positions. This movement
is controlled by two independent return springs.
1
2
For 536LiLX (US), serial number 182500300-: Push the
power trigger lockout (1) forward (A) and then press it.
When you do this it releases the power trigger (2). When
you release the handle the power trigger and the power
trigger lockout both move back to their original positions.
This movement is controlled by three independent return
springs.
1
2
Make sure the power trigger is locked when the power
trigger lockout is in its original position.
GENERAL SAFETY PRECAUTIONS
A
536LiLX (US), sn 182500300-
Press the power trigger lockout and make sure it returns
to its original position when you release it.
Check that the power trigger and the power trigger lockout
move freely and that the return spring works properly.
1
2
See instructions under the heading Start. Start the
machine and apply full power. Release the power trigger
and check that the cutting attachment stops and remain at
a standstill.

Cutting attachment guard

Li-ion Li-ion
This guard is intended to prevent loose objects from being
thrown towards the operator. The guard also protects the
operator from accidental contact with the cutting
attachment.
Check that the guard is undamaged and not cracked.
Replace the guard if it has been exposed to impact or is
cracked.
Always use the recommended guard for the cutting
attachment you are using. See chapter on Technical data.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
536LiLX (US), sn 182500300-
2
1
536LiLX (US), sn 182500300-
2
1
3
English
–
11