Husqvarna 535iFR Manuel D'utilisation page 12

• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
To attach the handle
1. Remove the nut and screw from the bottom of the
handle.
2. Attach the handle onto the handlebar.
3. Align the screw hole in the handle with the screw
hole in the handlebar.
4. Put the screw into the screw hole at the bottom of
the handle and through the handlebar.
5. Attach the nut on the screw and tighten the nut.
12
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
• Only use original spare parts.
• Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
SAVE THESE
INSTRUCTIONS
Assembly
To assemble the handlebar
1. Put the handlebar into the bracket.
2. Attach the knob but do not tighten fully.
3. Adjust the handlebar to put the product in a good
operation position.
4. Tighten the knob fully.
To put the handlebar in transport
position
1. Loosen the knob.
609 - 003 - 11.12.2019