Continental Fireplaces Builder Serie Manuel D'installation Et D'utilisation page 55

13.4.2 glass burner removal
Remove the main door(s) from the appliance, see "main door removal / installation" section for detailed
A.
removal instructions.
Vacuum the glass media out of the appliance. Ensure you insert a clean bag into your vacuum cleaner.
B.
Remove the 12 screws securing the media tray, then remove the media tray from the appliance, as shown
C.
below.
Remove the 4 screws securing the burner, as shown below. Then slide the burner off of the orifice and
D.
remove from the appliance.
To reinstall the burner reverse these steps.
E.
13.5 valve train replacement
Remove the safety barrier and main door(s). See "main safety barrier removal / installation" and "main
A.
door removal / installation" sections for detailed removal instructions.
Remove the burners, see "burner removal" section.
B.
Remove the 12 screws holding the valve train in place, as shown below.
C.
note:
A new gasket may be required when reinstalling the valve train assembly. Contact your local
authorized dealer/distributor.
Carefully lift the valve train assembly out far enough to access the manual shut off valve and turn to the
D.
off position. Disconnect the flex connector from the valve. You may now lift the valve train out of the
appliance.
note:
When reinstalling the burner, ensure that the venturi rests on the orifice.
D
D
C
W415-4051 / C / 06.29.22
maintenance
55
EN