Publicité
Les langues disponibles
Les langues disponibles
11.5
end door removal / installation (CBHD4PA only)
note:
One of the main safety barriers and doors must be removed prior to end barrier removal, see "main safety
barrier removal / installation" section and "main door removal / installation" sections for detailed instructions.
Remove the 6 screws securing the end door in place, as shown below. Ensure to keep one hand on
A.
the door, from the inside of the appliance, at all times to prevent it from falling.
Tilt the door from the top downwards and carefully remove it from the appliance.
B.
To install the end door, reverse these steps.
C.
11.6
control panel removal
Remove the main safety barrier, see "main safety barrier removal / installation" section.
A.
Remove the panel cover using the two finer holes, lift it up and away from the appliance, as shown below.
B.
Remove the control panel cover by lifting it up and off of the four shoulder screws, as shown below.
C.
6 screws
PANEL COVER
CONTROL
PANEL COVER
finishing
W415-4051 / C / 06.29.22
EN
41
Publicité
