Inventum MK650 Mode D'emploi page 11

After the preparation is completed, remove the lid upwards and pour or ladle the milk foam into a cup or bowl.
Do not remove the foam with a spoon or other metal object. This will damage the coating.
After having used the frother, clean the appliance as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 to 4 minutes before using it again.
TIPPS
• The best result is achievement when using whole milk.
• If the amount of milk of too low the result will not be good ­ less than 80 ml.
5
heating milk
Lift the lid and fit the mixer in the jug. Fill the desired amount of milk into the jug. Do not exceed the maximum of the top max. mark ­
MAX ­ 250 ml.
Put the lid back on the jug and place the appliance on the base. Start the preparation by pushing the button
The red control light will burn and the mixer will start turning. Depending on the filling volume, the preparation stops automatically
after 150 to 170 seconds. The control light goes out.
After the preparation is completed, remove the lid upwards and pour the hot milk into a cup. After having used the appliance, clean it
as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 to 4 minutes before using it again.
6
cleaning & maintenance
Before cleaning always unplug the appliance and let it cool down completely.
Clean the appliance immediately after every use.
Remove the whisk or the mixer by pulling it straight upwards. Clean the lid, the whisk and the mixer with warm soapy water. Dry the
parts thoroughly. Rinse the inside of the milk frother with hot water. Never use any aggressive or abrasives cleaning agents or sharp
objects that could damage the coating! Dry with a soft cloth. Make sure you remove all the milk residue from the inside. It is not
hygienic and can be harmful.
Never immerse the appliance, the power base, the power cord or plug in water or other liquids. Wipe the outside of the appliance with
a damp cloth regularly.
.
English •
11