2
appliance description
1.
Lid with sealing ring
2.
On/off button
3.
Handle
4.
Base with storage compartment
5.
Maximum indication for heating milk MAX
6.
Maximum indication for frothing MAX
7.
Whisk (frothing)
8.
Mixer (heating)
3
before the first use
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after unpacking for any visible
damage, possible from transportation. Place the appliance on a stable and heat resistant surface.
Clean the lid, the whisk and the mixer with warm soapy water. Dry the parts thoroughly. Make sure that the parts are completely dry.
Wipe the exterior and interior with a soft damp cloth and dry thoroughly. The appliance is only suitable heating and frothing milk.
Never fill the appliance with other drinks.
4
preparing milk foam
Check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance and plug
the appliance in. Lift the lid and fit the whisk in the jug. Fill the desired amount of milk into the jug. Do not exceed the maximum of
the lower max. mark MAX
capacity is 80 ml. Put the lid back on the jug and place the appliance on the base.
Frothing and heating
Press the button
to start the preparation. The red control light in the button will light up and the whisk will start turning. Depending
on the filling volume, the preparation stops automatically after 95 to 115 seconds. The control light goes out.
Just frothing
Press the button
for 1 to 2 seconds to start the preparation. The blue control light in the button will light up and the whisk will start
turning. Depending on the filling volume, the preparation stops automatically after 120 seconds. The control light goes out.
•
English
10
125 ml. Frothed milk expands and causes the pitcher to overflow, if filled up too high. The minimum
4
1
5
2
3
6
8
7