JVC FS-GD7 Manuel D'instructions page 15

Listening to the Radio
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Remote control:
1
sec.
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen
The MONO indicator lights on the display.
Reception will improve though stereo effect is
lost—Monaural reception mode.
To restore the stereo effect, press the button
again (the MONO indicator goes off).
FM AM
Main unit:
1
sec.
Remote
ONLY
To preset the stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2
Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing (5 seconds).
3
Select a preset number for the station you store.
4
Store the station.
To tune in to a preset station
1
Select a band (FM or AM).
2
Select a preset number you have stored.
• You can also use the 1/¡ buttons to select a preset
station.
Remote
ONLY
Examples:
To select preset number 5,
press 5.
To select preset number
15, press +10, then 5.
To select preset number
30, press +10, +10, then
10.
Remote
ONLY
FM AM
11