Faber e-BoX 1000/450-I Manuel D'installation page 22

Installation manual e-BoX 1000/450 I,ST

The warm air outflow is on one side and must
never be covered by the built-in construction.
See fig. 1.8.

Place or make a service door so that the water
tap, coarse / fine filter and plug are always
accessible for maintenance and calamities.
Ventilation
The e-BoX requires a minimum ventilation opening
of 420cm2.
Leave the openings in front of or under the e-BoX
open. See A and B in fig. 1.7.
Preparing the fireplace

Remove if necessary. decoration material
and keep it in a safe place. See chapter 6.

Make sure all packing materials are
removed.

Remove the transport brackets at the 4
corners, see fig. 1.5.
Taking out the glass
The glass is hanging on 4 hooks located on the
inside of the fireplace.

By first lifting the glass and then pulling it
forward it comes loose from the notches.
See fig. 1.6.

Take out the glass and keep it in a safe
place.
Placing the fire

Place the fire level and in the correct position.

Use opening A and B in the e-BoX for the
water- and power supply. See fig. 1.7.

Secure the fire with the 4 brackets see fig. 1.9.

Remove the transport blocks between Engine
and e-BoX and centre the Engine. See fig. 2.0.
Do a performance test. See chapter 5 and check all
water connections for leaks.

When no optional decoration set is ordered:
place the supplied deflector and base plate
(11687196). See fig. 2.3 and 2.4.
Replacing the glass is done in reverse order.

Please note!
The front of the see-through fireplace is the
warm air outflow.
Make sure that the small glass plate S is
placed on the warm air outlet side. See fig.
2.1
The glass may be cleaned with a standard window
cleaner.
22 < < < <
5 Functional test
See "Using the appliance for the first time" in
chapter 4 of the user manual.

Check the operation of the remote control.

Check the operation of heating fan.

Check all connections for water leaks.
The glass plate (s) will always be covered with
condensation during the starting process of about
15 minutes.

Please note!
An absorption valve / sponge at the bottom
of the unit will shut off the water supply
when an abundance of (condensation) water
flows from the reservoir. See fig.2.2.
6 Decoration set (optional)
Fuel bed

Please note!

Always use the supplied handles to place
the fuel bed.

Keep this handles for future use.
Placing the fuel bed

Remove the front glass. See chapter 4.4.

The fuel bed can be placed directly on the
unit. See fig. 2.0.

Make sure that the fuel bed is correctly
positioned and does not obstruct the
outflow opening of the Opti-myst effect.
Pebbles or Acrylic ice

Please note!
First place the supplied deflector and bottom
plate (11687196). See fig. 2.3 and 2.4.
Placing the pebbles/acrylic ice
Spread an even amount of pebbles or acrylic-ice on
the bottom plate.