Niko 350-20072 Mode D'emploi page 12

350-20072
Example 3: staircase
DIP switch 1 DIP switch 2
ON x
OFF
How the presence detector works:
- The lighting functions as a presence detector and is automatically switched on when the detector detects
movement in the detection area and the light level does not exceed the preset lux value.
- The lighting is automatically switched off again after a preset time (switch-off delay), provided that no
more motion is detected by the detector in the detection area or the light level has been higher than the preset
lux value for five minutes.
- The lighting can be switched on manually at any time via the push button, irrespective of the daylight level.
6. MAINTENANCE
Dirt may prevent the detector from functioning properly. Therefore, always keep the lens clean and dry. Use a
damp cloth and water with some detergent to clean the lens. Never exert pressure to wipe the lens clean. If the
lens or other parts of the detector are defective, please contact an authorised installer.
7. TECHNICAL DATA
dimensions
drill diameter
power supply voltage
power consumption
relay contact*
maximum load*
maximum switching capacity*
maximum inrush current*
light sensitivity*
hysteresis on light sensitivity
switch-off delay*
mounting height (fig. 3)
detection angle (fig. 3)
detection range (fig. 3)
cable input flush-mounting box (max. 14 mm) 4x with strain relief
wire input per connection terminal
protection degree
protection class
ambient temperature
quality mark
accessories
*indicates the value per channel, given that both channels have the same properties
8. WARNINGS REGARDING INSTALLATION
- The installation should be carried out by a registered installer and in compliance with the statutory regulations.
- This user manual should be presented to the user. It should be included in the electrical installation file, and
it should be passed on to any new owners. Additional copies are available on the Niko website or via the Niko
support service.
- During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this user manual, which only states general regulations and should therefore be read within the scope
of each specific installation.
- the rules of proper workmanship.
This product complies with all of the relevant European guidelines and regulations. If applicable, you can find
the EC declaration of conformity regarding this product at www.niko.eu.
9. NIKO SUPPORT
In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko support
service in Belgium at +32 3 778 90 80 or your wholesaler/installer. Contact details and more information
12
can be found at www.niko.eu under the "Help and advice" section.
10. GUARANTEE PROVISIONS
- The period of guarantee is four years from the date of delivery. The delivery date is the invoice date of
purchase of the product by the consumer. If there is no invoice, the date of production applies.
- The consumer is obliged to inform Niko in writing about the non-conformity, within two months after stating
the defect.
EN
All manuals and user guides at all-guides.com
DIP switch 3 DIP switch 4
x x x
46.4 x 100 mm (HxW)
133.4 x 100 mm (HxW) (incl. flush-mounting box supplied)
89 mm
230 Vac ± 10 %, 50 Hz
0,2 W
NO (max. 10 A), potential-free, light- and motion-sensitive
incandescent lamps (2300 W)
230 V halogen lamps (2300 W)
all low-voltage halogen lamps (500 VA)
fluorescent lamps (non-compensated) (1200 VA)
economy lamps (CFLi) (1200 VA)
140 μF
165 A/20 ms
20 – 1000 lux, ∞ lux
+ 10 %
2 – 60 min
2 – 3.4 m
360°
circular, 24 m (from a height of 3 m)
3 x 2.5 mm²
IP54
class I devices
-5 – +50 °C
CE marked in compliance with EN 60669-2-1
IR remote control (350-20089)
presence or absence detector 360° (slave) (350-20071 or
possibly 350-20079 or 350-20081)
nv Niko sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: support@niko.be — www.niko.eu
- In case of a non-conformity, the consumer only has the right to a product repair or replacement free of
charge, which shall be decided by Niko.
- Niko shall not be held liable for a defect or damage resulting from incorrect installation, improper or careless
use, incorrect operation, transformation of the product, maintenance that does not adhere to the maintenance
instructions or an external cause, such as damage due to moisture or overvoltage.
- The compulsory regulations of the national legislation concerning the sale of consumer goods and the
protection of the consumer in the countries where Niko sells, directly or via sister companies, subsidiaries,
chain stores, distributors, agents or permanent sales representatives, take priority over the above-mentioned
rules and regulations.
Do not dump this product with the unsorted waste. Bring it to a recognised waste collection point. Together with producers
and importers, you have an important role to play in the advancement of sorting, recycling and reusing discarded electrical
and electronic appliances. In order to finance the waste collection and processing, the government levies a recycling
contribution in some cases (included in the purchase price of this product).
PM350-20072R17192